Bakers Pride MT-200 - Manual (Page 16)

Convection Oven Maintenance
14
What to Do In Case of a Breakdown or Long Periods of Inactivity
1. Switch off the main electrical switch.
2. Set all control panel knobs to zero.
3. Inform technical assistance (only in case of a malfunction).
4. Clean the oven inside and out.
Troubleshooting
Refer to the table below for troubleshooting information.
PROBLEM
PROBABLE
CAUSE
REMEDY
Unit unplugged Check the plug connection and reconnect if necessary
Fuses Check the fuses and replace them if necessary
Cables/terminal
block Check the cables connection for loose wire and reconnect
if necessary
Switch
Check the switch and the voltage at the inlet and outlet.
Replace switch if necessary
Oven does not
turn on
Safety thermostat Check the safety thermostat and push the red button
Resistor contactor
Check the voltage at the inlet and outlet of the contactor
and replace if necessary
Heating element
burn out
Replace the heating element
Oven does not
warm up
Check the temperature with a manual thermometer and if
necessary replace the thermostat
Lights not lit Switch/lights Check the switch and the lights and replace if necessary
Motors do not
work
Motor
contactor/Motor Check the voltage at the inlet and out-
let of the contactor. Check the motor and replace the
contactor or the motor
if necessary
Safety thermostat Push the red button on the thermostat
Oven suddenly
stops
Short circuit
Check the fuses and replace them if necessary, if the
failure persists check all parts with an appropriate tester in
order to find which is the part to replace