Bakers Pride MT-200 - Manual (Page 8)

Convection Oven Installation
6
Installation
Safety Standards
The installer must read this booklet carefully before installing the convection
oven.
Installation and subsequent maintenance, cleaning, inspection and repairs must
be carried out with the electrical power supply disconnected.
Installation of the oven must be in compliance with current standards in the
country of use, otherwise BKI shall not honor the warranty in the event of direct
or indirect damage.
Installation, adjustment and assistance are to be carried out by qualified
personnel in compliance with current accident prevention legislation in the
country of use. The installer must also check for any fire prevention regulations.
BKI shall not be held liable for any damage arising from improper use of the
convection oven, unauthorized modifications and anything not covered by this
manual.
Environmental Standards
All materials used for packaging are compatible with environmental protection standards. They may be
stored without any hazard, or disposed of in accordance with current laws in the country of use. Do not
leave the plastic coverings within reach of children or animals as they are potentially hazardous. The
plastic components which can be disposed of and recycled are marked as follows:
 POLYETHYLENE: packaging outer film, instructions bag, etc.
 POLYPROPYLENE: clips, etc.
Transport and Unpacking
Any movement of the oven must be carried out by
suitable means such as a forklift or pallet loader.
These must be at least half as large as the convection
oven. If it is necessary to store the oven temporarily,
keep it in a covered, ventilated place at a temperature
from 14°F to 122°F, with humidity no higher than 95%.
Use protective gloves and remove the packaging. Lift
the oven with a forklift, remove the base and place it
in its intended location. After removing the packaging,
immediately check the condition of the oven. If in
doubt, do not use the oven. Contact an authorized
retailer.