Bakers Pride MT-200 - Manual (Page 18)

Convection Oven Maintenance
16
Outer Coverings
Remove the 4 rear fastening screws “C”.
Bulb, Heating Element and Motor Fan
It is necessary to access the inside of the oven, first removing pans, racks and related supports, and then
the conveyor.
30W Motor
Remove the fan by following the procedure outlined above, disconnect the motor from the electrical
system, loosen the 4 screws and replace the motor. Before re-installing the fan, check that there is no
friction between the motor shaft and the ring nut located inside the oven. If there is, loosen the fixing
screws of the ring nut and re-tighten them after eliminating the friction and having centered the ring nut on
the motor shaft.
Heating Elements
Disconnect the heating element connections outside the oven chamber. Loosen the heating elements
from inside the oven chamber and replace them.