BT PaperJet 60E - Manual (Page 20)

PaperJet 60E user guide – Edition 3 – 29.8.00
20
To fax from memory
Your PaperJet 60E has a memory which lets
you store one document for sending at a
pre-set time.
Place document face down in the document
feeder.
If necessary set the Contrast and Resolution
settings.
Display shows TX FROM MEMORY
The document is scanned into the memory.
Display shows
STORING then TYPE TIME
HH:MM
Enter the time at which you want your fax
to be sent, e.g. 18.30 or press the Start
button to select the current time.
Display shows TYPE FAX NUMBER
Use the keypad to dial the number you
want.
Display shows TYPE FAX NUMBER . If
required, enter the second number to which
you want to send your fax and press the
Start button again.
Repeat the last 2 steps until you have entered
all the numbers you want up to a maximum
of 10 when the display will show
END OF
LIST .
To finish.
To broadcast a document
You can set your machine to send a document to up
10 different numbers (broadcasting).
See “To fax from memory” below.
If using the 12 hour clock, press the Function
button to switch between a for AM and p for PM .
Press the < > buttons to move the cursor.
To change, re-send or cancel a stored
document
When you have stored a document in the
memory for sending later:
Display shows AUTOMATIC RX
MEMORY TX
Display shows TX FROM MEMORY
Display shows ALREADY ENTERED
Display shows PRINT SETTING?
/
/
PaperJet 60e_se 1-07-2003 18:30 Pagina 20