BT PaperJet 60E - Manual (Page 38)

38
Changing the settings:
Switch answering machine off and set your
PaperJet 60E to
AUTOMATIC RX mode.
Switch answering machine on –
to
TAD/FAX RX mode.
Record new OGM#1. Record your message
after entering the #3 code.
End OGM#1 recording.
Switch off message forwarding.
Switch on ANNOUNCE ONLY . Callers will hear
your OGM#1 only. They cannot leave a
message.
To stop.
To switch toll saver on/off
This feature can save you the cost of a remote
access call if you have no new messages.
If Toll Saver is switched on, your call will be
answered after the number of rings you have
set if you have new messages. (See “To set
the number of rings before your fax machine
takes a call”
page 40). If you do not have
new messages your call is answered after
another 2 rings. So if you hear extra rings,
you can hang up and save the cost of the
call. The default setting is on.
Press the Function button until the display
shows
TAD SET UP
Press the Start button.
Press the Function button until the display
shows
TOLL SAVER
Press the Start button to switch Toll Saver
on. Display shows:
ON .
Press to switch between
ON and OFF
Press the Start button to confirm.
Press the Stop button to return to standby.
#1
#2
#3
#4
#5
#6
0
NOTE
If messages were started using 1 (new message)
then 3 takes you to the start of the current message.
If messages were started using 2 (all messages) then
3 takes you to the start of the previous message.
PaperJet 60e_se 6-06-2003 16:50 Pagina 38