Bell'O 8160 - Manual (Page 14)

English
Concrete
Figure 10
EA
U
T
After the holes are drilled, remove the template and place two ALLIGATOR ® Anchors (U) into the
concrete wall as shown in Figure 9.
Figure 9
U
After you have prepared the two holes for mounting the Extension Arm (EA), install the extension
arm by inserting the two Lag Bolts (T) through the mount and into the holes (See Figures 7 and
10). After checking that the extension arm is level, tighten both lag bolts fully, but be careful not to
over-tighten.
3" (76mm) minimum
hole depth