Bell'O 8160 - Manual (Page 18)

Adjusting your mount
After your TV is installed, you can adjust the tilt and horizontal position. The tilt knob carries the
weight of the TV and must be tightened with the supplied Allen Key Tool (Y) after the desired position
of the monitor is achieved. Tighten the tilt knob until the TV is firmly locked in position. Refer again
to Figure 11 for information on locating each of these knobs.
Do not loosen the screw on the opposite side (see Figure 15) because
it holds the tilt assembly together.
If you plan to adjust the position of your TV regularly, you can tighten the horizontal pan
knob by hand (see Figure 16). To keep it in a permanently locked position, however, you need
to tighten it with the supplied Allen key. Under no circumstances should you completely loosen
and/or remove any of these knobs.
DO NOT
LOOSEN
SCREW
ADJUST KNOB
FROM THIS
SIDE ONLY
Figure 15 Figure 16
English