Brother HL 2700CN - Manual (Page 103)

4 - 15 OPTIONS
6
Put the main controller board back into the printer by sliding it into the guide rails.
Figure 4-24
7
Put the metal plate back on and secure the metal plate with the two screws.
8
Reconnect the interface cable (printer cable) to your computer. Plug the printer back in, and then
turn on the printer power switch.
To check that you have installed the SO-DIMM properly, you can print the Print Settings listing that
shows the current memory size. To print the Print Settings listing,see PRINT SETTINGS on page
3-10.