Hale AutoFill-E Tank Refill Control System - Manual (Page 5)

5 AUTOFIll-E Installer / User Guide
p/n: 029-0020-81-0
Safety Precautions
❑
1 Safety Precautions
IMPORTANT !
THE HALE “AUTOFILL - E” TANK REFILL CONTROL SYSTEM IS DESIGNED
FOR OPTIMUM SAFETY OF ITS OPERATORS. FOR ADDED PROTECTION
AND BEFORE ATTEMPTING INSTALLATION OR OPERATION PLEASE FOL-
LOW THE SAFETY GUIDELINES LISTED IN THIS SECTION AND ADHERE TO
ALL WARNING, DANGER, CAUTION AND IMPORTANT NOTES FOUND WITHIN
THIS GUIDE.
THIS SECTION ON SAFETY MUST BE CAREFULLY READ, UNDERSTOOD
AND ADHERED TO STRICTLY BY ALL INSTALLERS AND OPERATORS
BEFORE ATTEMPTING TO INSTALL OR OPERATE THE AUTOFILL - E TANK
REFILL CONTROL SYSTEM.
WHEN DEVELOPING DEPARTMENTAL APPARATUS OPERATING PROCE-
DURES, INCORPORATE THE WARNINGS AND CAUTIONS AS WRITTEN.
AutoFill is a trademark of Hale Products, Incorporated. All other brand and product
names are the trademarks of their respective holders.
1.1 GUIDELINES
NOTICE !
THE PROCEDURES IN THIS MANUAL ARE GENERAL OPERATING PROCE-
DURES. THEY DO NOT REPLACE THE PROCEDURES, POLICIES, GUIDE-
LINES ESTABLISHED BY THE AUTHORITY HAVING JURISDICTION, NOR DO
THEY REPLACE THE RECOMMENDATIONS AND PROCEDURES PROVIDED
IN THE APPARATUS MANUFACTURER'S MANUAL.
REFER TO THE PROCEDURES PROVIDED BY THE AUTHORITY HAVING
JURISDICTION ON SETTING WHEEL CHOCKS, AS WELL AS LAYOUT AND
CONNECTION OF HOSES, VALVES AND DRAIN COCKS.
Read all instructions thoroughly before beginning
any installation or operation process.
❑ Installation should be performed by a trained and qualified installer, or
your authorized Hale Products service representative. Be sure the
installer has sufficient knowledge, experience and the proper tools before
attempting any installation.