Hale AutoFill-E Tank Refill Control System - Manual (Page 6)

❑ Safety Precautions
6 AUTOFIll-E Installer / User Guide
p/n: 029-0020-81-0
❑ The installer is responsible for observing all instructions and safety pre-
cautions in his or her daily routine as dictated by regional safety
ordinances or departmental procedures.
❑ DO NOT permanently remove or alter any guarding or insulating devices,
or attempt to operate the system when these guards are removed.
Make sure all access/service panels and covers are installed, closed and
latched tight, where applicable.
❑ DO NOT remove or alter any hydraulic or pneumatic connections, electri-
cal devices, etc. DO NOT tamper with or disconnect safety features or
modify protective guards (such as covers, or doors). DO NOT add or
remove structural parts.
WARNING !
NO MODIFICATIONS OR ADDITIONS MAY BE MADE TO THE AUTOFILL-E
TANK REFILL SYSTEM WITHOUT PRIOR WRITTEN PERMISSION FROM:
Hale Products, Incorporated
Fire Suppression Division
700 Spring Mill Avenue
Conshohocken, PA 19428 U.S.A.
Telephone: ........................610-825-6300
Fax: ...................................610-825-6440
❑ Before connecting the wiring harnesses, inspect the seals and seal
washer in the connectors. There are seals on the male and female con-
ductors and on the tower.
If a seal washer is missing or damaged, water can enter the connector
causing pin and terminal corrosion. This could resulting in possible sys-
tem failure.
❑ Rotating drive line parts can cause injury.
Any valve operated by an electric motor causes the associated hand
wheel to turn. Be extremely careful that NO part of your body (head,
feet, arms, legs, fingers, hair, clothing, jewelry, etc.) is in an area of rotat-
ing parts where you could be subject to injury.
❑ Make sure everyone is clear of the apparatus. Verify the parking brake is
set and the wheels are chocked to prevent any movement of the
apparatus.