BNC 845-M - Manual (Page 19)

19
Model 845-M Programmer’s Manual V1.1 2011
SCPI Command Description
:ABORt Subsystem
The :ABORt command is a single command subsystem. There are no subcommands or associated data
parameters, as shown below. The :ABORt command, along with the :TRIGger and :INITiate commands,
comprise the Trigger group of commands.
Command Parameters Unit
(default)
Remark
:ABORt V0.3.10
:ABORt
:ABORt
This command causes the List or Step sweep in progress to abort. Even if INIT:CONT[:ALL] is set to ON,
the sweep will not immediately re-initiate.