BNC 845-M - Manual (Page 44)

44
Model 845-M Programmer’s Manual V1.1 2011
TRIGGer[:SEQuence]:RETRigger ON|OFF|IMMediate
TRIGGer[:SEQuence]:RETRigger?
This command enables or disables the ARB retriggering mode; the retrigger mode controls how the
retriggering function performs while a waveform is playing.
ON (1) This choice specifies that if a trigger occurs while a waveform is playing, the
waveform will retrigger at the end of the current waveform sequence and play once
more.
OFF (0) This choice specifies that if a trigger occurs while a waveform is
playing, the trigger will be ignored.
IMMediate This choice specifies that if a trigger occurs while a waveform is
playing, the waveform will reset and replay from the start immediately upon
receiving a trigger.
*RST ON
:TRIGger[:SEQuence]:ECOunt
TRIGGer[:SEQuence]:ECOunt <value>
TRIGGer[:SEQuence]:ECOunt?
This command sets a modulo on consecutive trigger events. Setting the value to N means that only
every Nth trigger event will be considered. Setting it to one means will use every trigger event that
does not occur during a running sweep.
*RST 1
Range 1 to 255
:TRIGger[:SEQuence]:OUTPut:POLarity
TRIGGer[:SEQuence]:OUTPut:POLarity NORMal|INVerted
TRIGGer[:SEQuence]:OUTPut:POLarity?
This command sets the trigger output signal polarity. Note that the trigger output must be
enabled by sending the [:SOURce]:LFOutput:SOURce TRIGger command.
*RST NORM
:TRIGger[:SEQuence]:OUTPut:MODE
TRIGGer[:SEQuence]:OUTPut:MODE NORMal|GATE|POINt This
command sets the trigger output signal mode.
NORMal The trigger output signal is pulsed once whenever playing a waveform
sequence is triggered.
GATE The trigger output signal is set when playing a
waveform sequence is triggered, and reset when playing stops.
POINT The trigger output signal is pulsed for each point of the sweep (list)
playing.
Note that the trigger output must be enabled by sending the [:SOURce]:LFOutput:SOURce
TRIGger command.
*RST NORM