BNC 845-M - Manual (Page 50)

50
Model 845-M Programmer’s Manual V1.1 2011
:LAN:KEEP:TIMeout (not implemented)
:SYSTem:COMMunicate:LAN:KEEP:TIMeout <value>
:SYSTem:COMMunicate:LAN:KEEP:TIMeout?
This command sets the length of time for the TCP Keep Alive setting.
Range 0 sec to 3600 sec
:LAN:RESTart
:SYSTem:COMMunicate:LAN:RESTart
This command restarts the network to enable changes that have been made to the LAN setup.
:LAN:SUBNet
:SYSTem:COMMunicate:LAN:SUBNet <ipstring>
:SYSTem:COMMunicate:LAN:SUBNet?
This command sets the signal generator’s local area network (LAN) subnet mask address for your
internet protocol (IP) network connection.
:SOCKet:ECHO
:SYSTem:COMMunicate:SOCKet:ECHO
This command turns the echo from the Model 845-M controller on or off. Echo is typically turned on
only for a telnet session. The Model 845-M returns a “>>” prompt when ready.