BNC 845-M - Manual (Page 48)

48
Model 845-M Programmer’s Manual V1.1 2011
[:SYSTem:COMMunicate] Subsystem
Command Parameters Unit
(default)
:SYSTem:COMMunicate:LAN:CONFig DHCP|MANual|AUTO DHCP
:SYSTem:COMMunicate:LAN:DEFaults V0.4.1
:SYSTem:COMMunicate:LAN:DHCP:TIMeout N/A 30 sec
:SYSTem:COMMunicate:LAN:GATeway <ipstring> “0.0.0.0”
:SYSTem:COMMunicate:LAN:IP <ipstring>
:SYSTem:COMMunicate:LAN:RESTart
:SYSTem:COMMunicate:LAN:SUBNet <ipstring> “255.255.255
.0”
:SYSTem:COMMunicate:SOCKet:ECHO ON|OFF|1|0 OFF
:LAN:CONFig
:SYSTem:COMMunicate:LAN:CONFig DHCP|MANual|AUTO
:SYSTem:COMMunicate:LAN:CONFig?
This command sets the signal generator’s internet protocol (IP) address.
MANual The user assigns an IP address to the signal generator.
DHCP The network assigns an IP address to the signal generator. If DHCP fails,
manual configuration will be used.
AUTO The network assigns an IP address to the signal generator with a
fallback to Auto- IP if DHCP fails. If both DHCP and Auto- IP fail, manual
configuration will be used.
:LAN:DEFaults
:SYSTem:COMMunicate:LAN:DEFaults
This command restores the instrument’s LAN settings to their factory default values.
:LAN:DESCription (not implemented)
:SYSTem:COMMunicate:LAN:DESCription <string>
:SYSTem:COMMunicate:LAN:DESCription?
This command defines the instrument’s web description. The query returns the current saved
setting.
:LAN:DHCP:TIMeout (not implemented)
:SYSTem:COMMunicate:LAN:DHCP:TIMeout {30}|60|90|120sec
:SYSTem:COMMunicate:LAN:DHCP:TIMeout?
This command enables the user to change the maximum length of time that the instrument will spend
trying to acquire an IP address using DHCP. If the LAN Config Type is set to Auto, then
the Auto- IP protocol will be used as a fall- back when time- out does occur. The DHCP timeout value is
stored in the same non- volatile ram as the other LAN configurations. The query returns the current
setting, not the saved setting.
Default 30 Seconds
:LAN:DOMain (not implemented)
:SYSTem:COMMunicate:LAN:DOMain <string>
:SYSTem:COMMunicate:LAN:DOMain?