BNC 845-M - Manual (Page 49)

49
Model 845-M Programmer’s Manual V1.1 2011
This command defines the domain name of the signal generator’s DNS server. This entry defines the
DNS server for the signal generator LAN connection. The query returns the current setting, not the
saved setting.
:LAN:DNS:DYNamic (not implemented)
:SYSTem:COMMunicate:LAN:DNS:DYNamic ON|OFF|1|0
:SYSTem:COMMunicate:LAN:DNS:DYNamic?
This command turns dynamic Domain Name System (DNS) on/off. The query returns the current
setting, not the saved setting.
:LAN:DNS:OVERride (not implemented)
:SYSTem:COMMunicate:LAN:DNS:OVERride ON|OFF|1|0
:SYSTem:COMMunicate:LAN:DNS:OVERride?
This command enables you to override the DNS server that is returned by the DHCP server. The LAN
configuration type must be set to Auto or DHCP to use this feature. The query returns the current
setting, not the saved setting.
:LAN:DNS[:SERVer] (not implemented)
:SYSTem:COMMunicate:LAN:DNS[:SERVer] <ipstring>
:SYSTem:COMMunicate:LAN:DNS[:SERVer]?
This command defines the IP address of the signal generator DNS server. This entry defines the DNS
server for the signal generator LAN connection. The query returns the current setting, not the saved
setting.
:LAN:GATeway
:SYSTem:COMMunicate:LAN:GATeway <ipstring>
:SYSTem:COMMunicate:LAN:GATeway?
This command sets the gateway for local area network (LAN) access to the signal generator from
outside the current sub- network. The query returns the current setting, not the saved setting.
:LAN:HOSTname
:SYSTem:COMMunicate:LAN:HOSTname <string>
:SYSTem:COMMunicate:LAN:HOSTname?
This command sets the signal generator’s local area network (LAN) connection hostname.
Maximum 29 characters are allowed. The query returns the current setting, not the saved
setting.
:LAN:IDENtify (not implemented)
:SYSTem:COMMunicate:LAN:IDENtify ON|OFF|1|0
This command controls the LAN identify feature. ON(1) The command enables device
identification by displaying the full- screen message
"Identify: <IP Address>" on the signal generator's front panel; the LAN Status indicator will also show
"IDENTIFY". For more information, refer to the Programming Guide.
OFF(0) This command disables device identification by clearing the message on the signal
generator's front panel and returning the LAN Status indicator to display the
current network state. For more information, refer to the Programming Guide.
:LAN:IP
:SYSTem:COMMunicate:LAN:IP <ipstring>
:SYSTem:COMMunicate:LAN:IP?
This command sets the signal generator’s local area network (LAN) internet protocol (IP) address for
your IP network connection.