BNC 835-3 User Manual - Manual (Page 13)

Rescan devices Connect / Disconnect Network Configuration
device selection
Basic CW Operation
The 835-3 is a laboratory instrument designed to generate a synthesized CW signal with
good spectral purity and variable amplitude. To set a desired frequency, relative phase
and amplitude, click to the CW tab (Figure 6). The desired frequency, phase, and power
can be set by clicking on the up and down arrows above and below each digit. The
frequency is settable in steps of 0.001 Hz, the phase is settable in steps of 0.1 deg, and
the power in steps of 0.1 dB.
The RF ON/OFF button turns the RF power on and off. The green LED in the RF ON
button indicates that the RF output is enabled.
The Save to Memory button allows you to save the current frequency/power pair to be
stored in one of the ten internal memory states.
Figure 6 CW tab
13