BNC 835-3 User Manual - Manual (Page 41)

Safety
FCC notice
This equipment has been tested and found to comply with the limits for a Class A device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area may cause harmful interference
in which case the user will be required to correct the interference at his or her own
expense.
notice
The 835-3 Signal Generator meets the intent of the EMC directive 89/336/EEC
and have been designed to EN61326 Class A Emissions and Immunity standard.
The 835-3 also meets the intent of the Low Voltage Directive and have been designed
to meet the IEC 61010-1:2001 (safety requirements for electrical equipment, control,
and laboratory use) standard.
Warranty Information
All BNC instruments are warranted against defects in material and workmanship for a
period of one year from the date of shipment. BNC will, at its option, repair or replace
products that prove to be defective during the warranty period, provided they are
returned to BNC and provided the preventative maintenance procedures are followed.
Repairs necessitated by misuse of the product are not covered by this warranty. No other
warranties are expressed or implied, including but not limited to implied warranties of
merchantability and fitness for a particular purpose. BNC is not liable for
consequential damages.
The warranty on the internal rechargeable batteries (option B3) is one year from the date
of shipment. Battery replacement is available through BNC and its distributors.
Equipment Returns
For instruments requiring service, either in or out of warranty, contact your local
distributor or the BNC Customer Service Department at the address given below for
pricing and instructions before returning your instrument.
When you call, be sure to have the following information available:
• Model number.
• Serial number.
41