AEM 30-2500 AQ-1 Data Logging System - Manual (Page 13)

Page 13 10-2500 AQ1 Instructions RevD 102512.doc
SERIAL/GPS
The Serial/GPS page is used to configure the AQ1 Data Logger to read data on the
RS232 input. When using a GPS, the input mode must be set to GPS. The baud rate
selected must match the GPS baud rate. (See the GPS instructions for the GPS baud
rate.) The sample rate is the rate at which the AQ1 Data Logger records the data.
When logging the data stream from an AEM EMS, the input mode must be set to AEM
EMS. The baud rate must be set to 19200. Figure 17 below shows the AQ1 Data
Logger configured to log an AEM EMS.
Recommended GPS Sensors
– Refer to page 6 for wiring instructions.
Garmin GPS18x PC
– 1 Hz model with DB9 connector and 12 volt power adapter
Garmin GPS18x 5Hz – 5 Hz OEM model, some wiring required.
Figure 16. Accelerometer Page
Figure 17. AQ1 Configured To Read AEM EMS Data Stream