AEM 30-2500 AQ-1 Data Logging System User Manual
Page 3
Page 3
10-2500 AQ1 Instructions RevD 102512.doc
A drill template for the AQ1 Data Logger is provided on the last page of the instruction
manual. Drill the four mounting holes with a 3/16
” drill bit. With the dust cover on the
AQ1 Data Logger module, secure the module using the supplied 6-
32 x 1 ¼” stainless
screws and nuts. Some resistance will be felt when inserting the mounting screws for
the first time as the screws will pierce the dust cover. A sharp pick or paper clip can be
used to make pilot holes in the dust cover if desired. Note: the dust cover is made of
a specially selected material that allows the cover to be flexible, yet does not rip
or tear.
WIRING
Power Connections
RED (PERM PWR)- Connect to a fused (5 Amp) constant 12 volt power source.
RED (SWIGN)
– Connect to a fused (5 Amp) switched 12 volt power source.
BLACK (BATT GND)
– Connect to a clean power ground. (Do not connect to a sensor
ground)
AEMnet
AEMnet is an open architecture software and hardware interface based on the CAN 2.0
specification, which provides the ability for multiple enabled devices to easily
communicate with each other through a single cable. The hardware connection is made
through a Deutsch 4P DTM connector and contains 12 volt switched power and ground
(2A max) as well as the CAN data lines. Devices connected to the AEMnet transmit
data through this one connection and most of these devices receive power from this
same connection as well.
The following AEM products are currently AEMnet enabled:
Figure 1. Common Mounting Orientations