AEM 30-2500 AQ-1 Data Logging System - Manual (Page 16)

Page 16 10-2500 AQ1 Instructions RevD 102512.doc
A user may configure the location where the log files are downloaded and saved to on
the
‘Log Files’ page as shown in Figure 21. In addition, there is a command button to
manually download logs from source folders other than the AQ-1; for example, an SD
card mounted in an external card reader. Manual log download from the AQ-1 and log
delete buttons are also available.
DEVICE INFORMATION
The Device Information section of the AQ1 Data Logger software is in the lower left
corner of the screen and is visible in every page. The total data rate, memory card
usage, and remaining log time are shown, as well as the device serial number and
firmware version. The status of the AQ1 Data Logger is also shown at the bottom left
corner of the screen. When the AQ1 Data Logger is connected
to the software, “Logger
Connected” will appear. The software will read “No Device Connected” when the AQ1
Data Logger is not connected. See Figure 22 below.
SD CARD
The AQ1 Data Logger comes with a removable 2GB card that is located on the back of
the logger. To remove the SD card, push the card in until a soft click is heard. The card
will release and can be pulled out. To insert the card, push the card in until a soft click
is heard. The card will remain locked in place. See Figure 23 below.
Figure 22. Device Information
Figure 23. SD Card Location On Back Of AQ1