AEM 30-3703 Infinity-8/10/12 Mini-Harness - Manual (Page 15)

15
© 2014 AEM Performance Electronics
Infinity Pin Hrdwr Ref. Hardware Specification Notes
C1-49 VR+_In_2 Differential Variable Reluctance
Zero Cross Detection See Non Driven Wheel Speed Calibration in the
Setup Wizard Vehicle Speed page.
C1-50 VR-_In_2
C1-51 VR-_In_3 Differential Variable Reluctance
Zero Cross Detection See Driven Wheel Speed Calibration in the Setup
Wizard Vehicle Speed page.
C1-52 VR+_In_3
C1-53 DBW1 Motor -_Out 5.0A max Throttle Control Hbridge
Drive +12V to close.
C1-54 DBW1 Motor +_Out 5.0A max Throttle Control Hbridge
Drive +12V to open.
C1-55 Power Ground_In Power Ground Connect directly to battery ground
C1-56 Injector 6_Out Saturated or peak and hold, 3A max
continuous Injector 6
C1-57 Injector 5_Out Saturated or peak and hold, 3A max
continuous Injector 5
C1-58 Injector 4_Out Saturated or peak and hold, 3A max
continuous Injector 4
C1-59 Injector 3_Out Saturated or peak and hold, 3A max
continuous Injector 3
C1-60 Power Ground_In Power Ground Connect directly to battery ground
C1-61 +12V_In 12 volt power from relay 12 volt power from relay. Relay must be
controlled by +12V Relay Control signal, pin C1-29
above.
C1-62 Injector 2_Out Saturated or peak and hold, 3A max
continuous Injector 2
C1-63 Injector 1_Out Saturated or peak and hold, 3A max
continuous Injector 1
C1-64 +12V_In 12 volt power from relay 12 volt power from relay. Relay must be
controlled by +12V Relay Control signal pin C1-29
above.
C1-65 +12V_SW_In 10K pulldown Full time battery power must be available at C1-
10 before this input is triggered.
C1-66 Analog_In_Temp_1 12 bit A/D, 2.49K pullup to 5V See "Coolant Temperature" Setup Wizard for
selection.