AEM Infinity Supported Applications - Dodge 2008-2010 Viper 4G - Manual (Page 19)

Infinity Supported Application 19
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware Reference
08–10 Dodge
Viper Function
08–10
Dodge
Viper Pin
Destination
Hardware Specification Notes
C2-43 LowsideSwitch_8
RAD Fan Relay
/ Control Engine
Protect Out
C4-3
Lowside switch, 4A max
with internal f ly back diode.
Inductiv e load should NOT
hav e f ull time power.
See Spare GPO1 Basic Setup section
of User GPIOs and PWM Setup Wizard
page LowSide Assignment Tables f or
additional options.
Activ ates if any of the f ollowing f lags
are true: OilPressProtectOut,
LeanProtectOut, CoolantProtect.
Output can be assigned to other
f unctions. See Setup Wizard page
LowSide Assignment Tables f or
additional options.
C2-44 LowsideSwitch_7
Rev erse Lock-
Out Control
C4-1
Lowside switch, 4A max
with internal f ly back diode.
Inductiv e load should NOT
hav e f ull time power. See Spare GPO1 Basic Setup section
of User GPIOs and PWM Setup Wizard
page LowSide Assignment Tables f or
additional options.
C2-45 UEGO 2 VM UEGO 2 VM
Bosch UEGO Controller
Virtual Ground signal. Connect to pin 5
of Bosch UEGO sensor.
C2-46 UEGO 2 UN UEGO 2 UN
Nernst Voltage signal. Connect to pin 1
of Bosch UEGO sensor.
C2-47 UEGO 2 IP UEGO 2 IP
Pumping Current signal. Connect to pin
6 of Bosch UEGO sensor.
C2-48 UEGO 2 IA UEGO 2 IA
Trim Current signal. Connect to pin 2 of
Bosch UEGO sensor.
C2-49 UEGO 2 HEAT UEGO 2 HEAT
Lowside switch f or UEGO heater
control. Connect to pin 4 of Bosch
UEGO sensor. NOTE that pin 3 of the
Sensor is heater (+) and must be power
by a f used/switched 12V supply .
C2-50 +12V_R8C_CPU
Battery Perm
Power
Dedicated power
management CPU
Optional f ull time battery power. MUST
be powered bef ore the ignition switch
input is triggered. (See C1-65.)
C2-51 Coil 7 Coil 7 C1-2 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C2-52 Coil 8 Coil 8 C2-3 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C2-53 Coil 9 Coil 9 C1-1 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C2-54 Coil 10 Coil 10 C2-2 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.