AEM Infinity Supported Applications - Honda H-Series Engine - Manual (Page 11)

Infinity Supported Application 11
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware Reference
7100-XXXX-62
7101-XXXX-63
Function
Dest.
Pin
Honda
OBD 1
Dest.
Pin
Honda
OBD
2a
Dest.
Pin
Honda
OBD
2b
Hardware
Specification
Notes
C1-71 Stepper_2B Stepper 2B
Automotiv e,
Programmable
Stepper Driv er,
up to 28V and
±1.4A
Be sure that each internal
coil of the stepper motor is
properly paired with the
1A/1B and 2A/2B ECU
outputs. Supports Bi-Polar
stepper motors only .
C1-72 Stepper_1B Stepper 1B
Automotiv e,
Programmable
Stepper Driv er,
up to 28V and
±1.4A
Be sure that each internal
coil of the stepper motor is
properly paired with the
1A/1B and 2A/2B ECU
outputs. Supports Bi-Polar
stepper motors only .
C1-73 Power Ground Ground Power Ground
Connect directly to battery
ground.
C2-1 DBW2 Motor +
DBW Motor Control
Open
5.0A max
Throttle Control
Hbridge Driv e
+12V to open
C2-2 DBW2 Motor -
DBW Motor Control
Close
5.0A max
Throttle Control
Hbridge Driv e
+12V to close
C2-3 Power Ground Ground B2 A22 B22 Power Ground
Connect directly to battery
ground.
C2-4 Injector 7 Injector 7
Saturated or
peak and hold,
3A max
continuous
Injector 7
C2-5 Injector 8 Injector 8
Saturated or
peak and hold,
3A max
continuous
Injector 8
C2-6 Injector 9 Injector 9
Saturated or
peak and hold,
3A max
continuous
Injector 9
C2-7 Injector 10 Injector 10
Saturated or
peak and hold,
3A max
continuous
Injector 10
C2-8 Power Ground Ground Power Ground
Connect directly to battery
ground.
C2-9 +12V +12V In
12 v olt power
f rom relay
12 v olt power f rom relay .
Relay must be controlled by
+12V Relay Control signal,
pin C1-29 abov e.
C2-10 Injector 11 Injector 11
Saturated or
peak and hold,
3A max
continuous
Not used
C2-11 Injector 12 Injector 12
Saturated or
peak and hold,
3A max
continuous
Not used