AEM Infinity Supported Applications - Honda H-Series Engine - Manual (Page 6)

6
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware Reference
7100-XXXX-62
7101-XXXX-63
Function
Dest.
Pin
Honda
OBD 1
Dest.
Pin
Honda
OBD
2a
Dest.
Pin
Honda
OBD
2b
Hardware
Specification
Notes
C1-18 LowsideSwitch_3 MIL Output A13 A18 A18
Lowside switch,
4A max with
internal f ly back
diode. Inductiv e
load should NOT
hav e f ull time
power.
See Wizard page "LowSide
Assignment Tables" f or
output assignment.
MIL Activ ates when any of
the f ollowing f lags are true:
ErrorAirTemp, ErrorBaro,
ErrorCoolantTemp, ErrorEBP,
ErrorFuelPressure,
UEGO_0_Diag_error,
UEGO_1_Diag_error,
ErrorMAFAnalog,
ErrorMAFDigital, ErrorMAP,
ErrorOilPressure,
ErrorThrottle.
C1-19 AGND_1 Sensor Ground D21 D12 C7
Dedicated
analog ground
Analog 0–5V sensor ground
C1-20 AGND_1 Sensor Ground D22 D11 C18
Dedicated
analog ground
Analog 0–5V sensor ground
C1-21
Crankshaf t Position Sensor
Hall
Crankshaf t
Position Sensor
Hall
10K pullup to
12V. Will work
with ground or
f loating
switches.
See Setup Wizard page Cam/
Crank f or options.
C1-22
Camshaf t Position Sensor 1
Hall Camshaf t Position
Sensor 1 Hall
10K pullup to
12V. Will work
with ground or
f loating
switches.
See Setup Wizard page Cam/
Crank f or options.
C1-23 Digital_In_2
Camshaf t Position
Sensor 2 Hall
10K pullup to
12V. Will work
with ground or
f loating
switches.
See Setup Wizard page Cam/
Crank f or options.
C1-24 Digital_In_3 Turbo Speed Hz
10K pullup to
12V. Will work
with ground or
f loating
switches. See Setup Wizard page Turbo
Speed f or calibration
constant. TurboSpeed [RPM]
= Turbo [Hz] * Turbo Speed
Calibration.
C1-25 Digital_In_4
Vehicle Speed
Sensor
*B10 *C18 *C23
10K pullup to
12V. Will work
with ground or
f loating
switches.
See Setup Wizard page Input
Function Assignment f or
calibration constant.
C1-26 Digital_In_5 Flex Fuel
10K pullup to
12V. Will work
with ground or
f loating
switches.
See channel FlexDigitalIn
[Hz] f or raw f requency input
data.
C1-27 Knock Sensor 1 Knock Sensor 1 D3 D6 C3
Dedicated
knock signal
processor
See Setup Wizard page
Knock Setup f or options.
C1-28 Knock Sensor 2 Knock Sensor 2
Dedicated
knock signal
processor
See Setup Wizard page
Knock Setup f or options.