AEM Infinity Supported Applications - Mitsubishi 2006 Evolution IX Engine - Manual (Page 11)

Infinity Supported Application 11
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware
Reference
7100-XXXX-62
7101-XXXX-63
Function
Dest.
Pin
Evo
VIII
Dest.
Pin
Evo IX
Hardware Specification Notes
C1-9 Flash_Enable Flash Enable 10K pulldown
Not usually needed f or automatic
f irmware updates through Inf inity
Tuner. If connection errors occur
during update, connect 12 v olts to
this pin bef ore proceeding with
upgrade. Disconnect the 12 v olts
signal af ter the update.
C1-10 +12V_R8C_CPU
Battery Perm
Power
80 60
Dedicated power management
CPU
Full time battery power. MUST be
powered bef ore the ignition switch
input is triggered. (See C1-65.)
C1-11 Coil 4 Coil 4 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C1-12 Coil 3 Coil 3 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C1-13 Coil 2 Coil 2 23 12 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C1-14 Coil 1 Coil 1 10 11 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C1-15 Coil 6 Coil 6 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C1-16 Coil 5 Coil 5 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary . Must
use an ignitor OR CDI that accepts a
FALLING edge f ire signal.
C1-17 LowsideSwitch_2
Coolant Fan 1
Control
32, 34 30, 31
Lowside switch, 4A max, NO
internal f ly back diode. See "LowSide Assignment Tables" f or
output assignment.
C1-18 LowsideSwitch_3 MIL Output 36 22
Lowside switch, 4A max with
internal f ly back diode.
Inductiv e load should NOT
hav e f ull time power.
See Wizard page "LowSide
Assignment Tables" f or output
assignment.
MIL Activ ates when any of the
f ollowing f lags are true: ErrorAirTemp,
ErrorBaro, ErrorCoolantTemp,
ErrorEBP, ErrorFuelPressure,
UEGO_0_Diag_error,
UEGO_1_Diag_error,
ErrorMAFAnalog, ErrorMAFDigital,
ErrorMAP, ErrorOilPressure,
ErrorThrottle.
C1-19 AGND_1 Sensor Ground 92 49 Dedicated analog ground Analog 0–5V sensor ground