Blaupunkt Dallas RMD 169 - Manual (Page 10)

10
The ignition is off and LED ON is se-
lected in the DSC menu (factory de-
fault setting).
Further information: “Programming
with DSC, LED ON/OFF”.
@ KeyCard anti-theft protection sys-
tem
The KeyCard must be inserted before
the unit can be operated.
KeyCard
Inserting the KeyCard
To disengage the control panel, press
key
1 . The control panel folds down.
Insert the KeyCard with the contact
surface facing downwards (see dia-
gram). Engage the control panel.
2
1
3
; CDC
Switch to changer mode (only if a
changer is fitted).
If a changer is not fitted, AUX is selec-
ted. Condition: AUX ON must be se-
lected in the DSC menu.
<
MD
Switch to MiniDisc mode.
=
TU (TUNER)
For switching to the radio mode, for
toggling between FMI, FM II, TS (Trav-
elstore), AM and AMT memory levels/
frequency bands.
>
Slot for MiniDisc
When the MiniDisc is inserted with the
label facing upwards it is automatically
transported into the operating position.
MiniDisc play mode is selected auto-
matically.
? Visual anti-theft protection
The following conditions must be met if
the LED is to flash as a visible anti-
theft protection measure:
The unit is switched off;
The control panel is open;
The KeyCard is removed;
Condensed instructions
Remove the KeyCard following the
procedure in reverse.
Important: read the information under
“KeyCard anti-theft protection system”.
A
Eject
Hold the key for MiniDisc ejection
down for approx. 2 seconds: the
MiniDisc is ejected.
For safety reasons, the control
panel must always be engaged
whilst the vehicle is moving.
When leaving the vehicle, open the
control panel and remove the Key-
Card in order to prevent theft.