Blaupunkt Dallas RMD 169 - Manual (Page 21)

21
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
b) With the seek run rocker << >>
If PTY is activated, you can select a
program type with << >>.
• Press << or >>: the last program
type selected is displayed for three
seconds.
• During this time, select the desired
program type with >> (forwards) or
<< (back).
• Press << or >> as many times as
necessary.
To listen to a station broadcasting this
program type:
• Start the seek run with / .
If no station broadcasting the selected pro-
gram type is found, “NO PTY” appears brief-
ly on the display, and the beep sounds. The
last station selected is played.
Storing the program type
A program type is stored on each of the keys
ST1 - ST6 by the factory.
You can however store other available pro-
gram types.
“PTY” must be displayed before you can
store a different program type.
•
If necessary, activate “PTY” using the
PTY key.
• Select the program type with << >>
and
• Hold the desired key (ST1- ST6) down
until the beep sounds.
The selected program type can be called up
by means of this key when PTY is activated
(“PTY” appears on the display).
Sampling stations with PTY-SCAN
Condition: “PTY” must be displayed.
• Press SCA.
The stations with this program type which
can be received are sampled briefly.
Deactivating PTY-SCAN:
•
Press SCA or the seek rocker again.
Following a frequency seek run, PTY-SCAN
is automatically deactivated.
PTY priority
Situation:
PTY is activated, the logo appears on the
display.
No station broadcasting the selected pro-
gram type can be received at this time (by
seek or by Scan).
The unit switches back to the previous sta-
tion.
As soon as a station broadcasting the se-
lected program type can be received within
the station chain, the unit switches to this
station in radio mode for the duration of the
program.
Example:
- Previous station: NDR 3.
- “PTY” on the display
- “POP” selected
- Seek run started
- No station with “PTY-POP” found
- Display shows “NO PTY” and
- Switches back to NDR 3 automatically
- NDR 2 is broadcasting “PTY-POP”
- Unit switches within the station chain
to NDR 2 and plays it as long as the
station continues to broadcast “POP”.
The unit also switches automatically in MD/
CDC mode to the station broadcasting the
selec-ted program type within the transmis-
sion chain.
When the PTY program is over, the unit
switches back to the source previously se-
lected (radio, MD or CDC).
Note:
As already mentioned, these functions are
not currently available with all RDS stations.
Radio operation with RDS (Radio Data System)