Blaupunkt Dallas RMD 169 - Manual (Page 13)

13
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
• Slide the card as far as possible to the
right, and remove from the front.
• Engage the control panel.
For safety reasons, the control
panel must always be engaged
whilst the vehicle is moving.
When leaving the vehicle, open the
control panel and remove the Key-
Card in order to prevent theft.
Teaching in a second KeyCard/
replacing a KeyCard
An additional KeyCard can be “taught in”
whilst the unit is in operation with the first
KeyCard.
To “teach in” a second KeyCard:
•
Slide the first KeyCard in and switch
the unit on.
• Press DSC and use / to select
“LEARN KC”.
• Press << or >>.
“CHANGE” appears on the display.
• Remove the first KeyCard and, with
“CHANGE” on the display, insert the
new KeyCard.
When “READY” or “LEARN KC” appears:
•
Press DSC.
2
1
3
• Slide the card in the direction of the ar-
row (2) and engage the control panel
(Arrow 3).
The car radio is ready for use.
Should a KeyCard other than that belong-
ing to the unit be inserted, CARD ERR” ap-
pears on the display.
The unit switches itself off after approx. 10
seconds.
Should a card other than a KeyCard be in-
serted (e.g. a phonecard or credit card),
“WRONG KC” is displayed for approx. 2
seconds.
In this case, remove the card and insert a
KeyCard for the unit.
•
Press ON to switch on the unit.
Removing the KeyCard
Disengage the control panel as follows
•
Press the knob 1 : the control panel
folds down forwards.
KeyCard anti-theft protection system
Two KeyCards are supplied with the unit.
Should you lose or damage a KeyCard, you
can obtain a replacement from a specialist
dealer.
If you are using two KeyCards, the settings
are taken from the first KeyCard.
You can customize the following functions:
Station key assignment, bass, treble, bal-
ance and fader settings, loudness, beep
volume, LOW-EQ, HIGH-EQ.
The last state selected such as frequency
band, station setting, AF, SCANTIME, seek
run sensitivity, ON VOL (volume at switch
on), SHARX, is also saved.
Your selected settings are therefore select-
ed automatically when you insert your Key-
Card.
Switching on the unit
• Switch on the unit with ON.
To insert the KeyCard, disengage the con-
trol panel:
•
Press the knob 1 : the control panel
folds down forwards.
• Insert the KeyCard with the contact
surface downwards, as shown in the
diagram (Arrow 1).