Blaupunkt Dallas RMD 169 - Manual (Page 14)

14
The unit is now also ready for operation with
the new KeyCard.
A maximum of two KeyCards can be taught
in.
If a third KeyCard is taught in, the card which
is not employed for the teaching-in process
of the new card automatically loses its va-
lidity.
Displaying the radio passport
data
You can use the KeyCard supplied to call
up the radio passport data such as the unit
name, type number (7 6 ...) and serial num-
ber on the display.
Refer to “Programming with DSC – READ
KC” for the procedure.
Visual display for anti-theft
protection
Anti-theft protection is provided in the form
of a flashing LED
?
when the vehicle is
parked and the KeyCard removed.
The following conditions must be met:
Battery positive and constant battery posi-
tive are connected as described in the in-
stallation instructions.
The unit is switched off; the control panel is
open; the KeyCard is removed; LED ON is
selected in the DSC menu (default factory
setting).
If necessary, refer to “Programming with
DSC – LED”.
Deactivating the flashing LED
Select “LED OFF” in the DSC menu to de-
activate the flashing LED.
Care of the KeyCard
The KeyCard will function perfectly only if
the contacts are kept free of foreign parti-
cles. Avoid touching the contacts directly
with your hands.
If necessary, clean the KeyCard contacts
using a cotton bud soaked in alcohol.
KeyCard lost/damaged
Should you damage or lose the KeyCard for
your unit, you can teach in a new KeyCard.
You can purchase the new KeyCard from
your dealer. You will also require the mas-
ter code for the unit, which can be found in
the car radio passport.
Keep the car radio passport in a safe
place, but not in the car.
Teaching in the new KeyCard
• Insert the new KeyCard and engage
the control panel.
• Press ON.
• Press TU and ST1 within 5 seconds:
“0000” appears on the display.
• Using the rocker, enter the four-digit
master code from the car radio pass-
port:
/ - Enter the digits (press once for
one, twice for two, etc.)
<< >> - Select the insertion point
• After entering the correct master code,
press ENT.
The new KeyCard is accepted when the unit
switches to play.
Input errors
Should the input not be correct, “CODE
ERR” appears on the display. After three
successive incorrect inputs, “WAIT 1h” ap-
pears on the display. The unit remains in
Wait mode for one hour.
• Switch the unit off and on again.
Repeat the teach-in process.
KeyCard anti-theft protection system