AiM SmartyCam ver 1.22 - Manual (Page 12)

SmartyCam
User Manual
Release 1.22 – firmware version 1.03.10
12
www.smartycam.com
Chapter 3 – SmartyCam connections
The alternative SmartyCam modes (Stand Alone or Slave Expansion) require different
connection procedures.
3.1 – Connecting SmartyCam stand alone
SmartyCam stand alone can be connected in different ways:
• connection to the external power only: use the 7-pins left connector highlighted in
the image above and connect the power cables to a 12 Volts power source i.e. the
vehicle battery. See appendix “B”.
• connection to the external microphone only: the external microphone plugs directly
in the 7 pins left connector highlighted in the image here above.
• connection to optional cables and external microphone: use the 7-pins connector
highlighted in the image here above and connect the power cables to an external 12
Volts power source.
• connection to the external GPS module: use the 4 pins right connector placed on
the product rear (see above).