AiM SmartyCam ver 1.22 - Manual (Page 13)

SmartyCam
User Manual
Release 1.22 – firmware version 1.03.10
13
www.smartycam.com
3.2 – Connecting SmartyCam Slave expansion with SMC 1 Bridges
In order to receive the info provided by the vehicle ECU without any additional logger,
SmartyCam must be used in Slave expansion mode and connected via CAN to an ECU
Bridge, using the 7-pins connector placed on the product rear.
There are two available ECU Bridges version:
• code X90BGGPI2R for connection with aftermarket racing ECU with CAN or RS232
communication protocol.
• code X90BGGPI2K for connection with stock ECU through the OBDII, no matter if
having a CAN communication protocol or the K line
Complete documentation on supported ECU is available at www.aim-sportline.com
“Download” area, ECU connection section.
Refer to appendix “B” of this user manual to know SmartyCam pinout, while SmartyCam
ECU Bridge connection is shown at
www.smartycam.com , “Connection” area, ECU Bridge
section.
PLEASE NOTE: refer to Race Studio Configuration user manual for more info about
AIM Bridges configuration, and to www.aim-sportline.com download area ECU
connections for more info about ECU supported by AIM systems and their
communication/connection protocols.
To use an RPM Bridge a CAN cable is needed. It is to be placed between SmartyCam 7
pins female Binder connector – left on the rear of the camera – and RPM Bridge 5 pins
female connector.
1 SMC = SmartyCam