AiM SmartyCam ver 1.22 - Manual (Page 22)

SmartyCam
User Manual
Release 1.22 – firmware version 1.03.10
22
www.smartycam.com
In all situations if GPS signal is “low” or “search”: please wait.
Please note: if SmartyCam track option is in manual mode and a track is transmitted
using SmartyManager software, the camera switches to “AUTO” mode.
“SHOW”
Shows the list of all tracks loaded: in bold the tracks that have a map associated, in grey
the tracks that have only lap beacon coordinates. In “Manual” mode it is also possible to
select the track to be used.
“TRACK INFO”
Shows for each track:
• the distance – In km and in miles – of SmartyCam from the lap beacon; if the
distance is lower than 5 km the name of the track is written in red;
• latitude and longitude of the lap beacon.
6.5 – How to record videos
It is possible to record images both manually and automatically
Warning: do not remove the Micro SD when SmartyCam is recording, no matter
how, or is in “Player” mode (Micro SD icon is red).Otherwise the Micro SD will be
permanently damaged.
6.5.1 – Manual recording
At switch on SmartyCam display shows the page here below on the right:
The keyboard (“A”) allows to:
• start recording, select “Rec”;
• switch SmartyCam off, select “Off”;
• enter “Menu Status”, select Menu”.
In the mid of the page (“B”)
• the real time image frame is visible;
To start recording, press “Rec”: SmartyCam will show this page:
The keyboard (“A”) allows to:
• stop recording select “Stop”: SmartyCam comes back
to “Online Status”;
• switch SmartyCam off, select “Off”;
The lower part (“C”) is “Satellites, Battery and Memory
Status” field.
• When SmartyCam is recording a red indicator appears
on the left .
After a pre-defined time of inactivity the display will switch off
(see paragraph 6.5.2).