AiM SmartyCam ver 1.22 - Manual (Page 14)

SmartyCam
User Manual
Release 1.22 – firmware version 1.03.10
14
www.smartycam.com
3.3 – SmartyCam in Slave expansion mode with AIM loggers
SmartyCam can visualize data sampled by an AIM logger (EVO3 Pro/Pista, EVO4, MXL
Strada/Pista/Pro05 or MyChron4) and by the vehicle ECU. In this case it is necessary to
connect SmartyCam via CAN to the logger, using the CAN cable inserted into the 7-pins
connector placed right of the product rear.
Please refer to appendix “B” of this manual for the SmartyCam pinout and to the
user manual of each AIM logger to know its pinout.
The image below shows SmartyCam connected to an EVO4 logger while SmartyCam-
EVO4 connection is explained at
www.smartycam.com , “Connections” area, EVO4
section..