AiM GSX-R 1000 - Manual (Page 9)

MXL P&P SUZUKI GSX-R K3
User Manual
Release 1.07
www.aim-sportline.com
1 8
2.1 – Removing the lateral mirrors and the front and lateral fairings
The first installation step is removing
lateral mirrors and front and lateral
fairings.
Lateral mirrors are fixed to the bike
chassis with two hex screws that have a
plastic cover. To remove the covers see
Figure 1.
Figure 1: plastic covers removal.
It is then possible to remove the hex
screws shown in Figure 2.
Both mirrors need to be removed.
Figure 2: hex screws.
Afterwords remove the front screen and
the right lateral fairing.
It is suggested to remove the front screen
to uninstall the stock dash and install the
new one.
The fairing is fixed to the bike with four
Phillips thread forming screws.
In Figure 3 the position of the screws is
shown: remove them.
Figure 3: front screen – 4 Phillips thread forming
screws.
The logger wiring is to be installed on the
bike right side.
It is only required removal of the right
lateral fairing, fixed to the chassis through
6 hex screws and four plastic pins. Screws
are red circled in Figure 4 while pins are
highlighted by red/yellow arrows in
Figures 4 and 5.
The plastic pin on Figure 4 is only visible
looking at the bike frontally.
Figure 4: right lateral fairing – screws and pins.
9