AirLive IAS-2000 v2 - Manual (Page 14)

IAS-2000 v2
User’s Manual
. 7
3.4 Installation Steps
Please follow the following steps to install IAS-2000 v2:
1. Connect the power cord to the power socket on the rear panel.
2. Turn on the power switch on the rear panel. The Power LED will light up.
3. Connect an Ethernet cable to one LAN port with the user authentication function enabled on the front panel.
The default port is LAN1 port. (Note: Authentication is required for the users to access the network via this LAN
port. The LAN port with authentication function is referred to as Public LAN.) Connect the other end of the
Ethernet cable to an AP or switch. The LED of this LAN port should be on to indicate a proper connection.