AirLive IAS-2000 v2 User Manual
Page 15
IAS-2000 v2
User’s Manual
.
8
4.
Connect an Ethernet cable to one LAN port with the user authentication function disabled on the front panel.
The default port is LAN2 port. (Note: No authentication is required for the users to access the network via this
LAN port. The LAN port without authentication function is referred to as Private LAN and the administrator can
enter the administrative user interface to perform configurations via Private LAN.) Connect the other end of
the Ethernet cable to a client’s PC. The LED of this LAN port should be on to indicate a proper connection.
5.
Connect an Ethernet cable to one of the WAN ports on the front panel. Connect the other end of the Ethernet
cable to ADSL modem, cable modem or a switch/hub of the internal network. The LED of this WAN should be
on to indicate a proper connection.
Attention: Usually a straight RJ-45 could be applied if IAS-2000 v2 is connected to a hub/computer which supports
automatic crossover, such as the Access Point. However, after the Access Point hardware reset, IAS-2000 v2
should not be able to connect to Access Point while connecting with a straight cable unless the cable was pulled out
and plug-in again. This scenario does NOT occur while using a crossover cable.
After the hardware of IAS-2000 v2 is installed completely, the system is ready to be configured in the following
sections. The manual will guide you step by step to set up the system using a single IAS-2000 v2 to manage the
network.