AirLive IAS-2000 v2 - Manual (Page 81)

IAS-2000 v2
User’s Manual
. 74
Click the hyperlink of RADIUS Setting for further configuration. The Radius server sets the external authentication
for user accounts. Enter the related information for the primary server and/or the secondary server (the secondary
server is not required). The blanks with red asterisks are necessary information. These settings will become
effective immediately after clicking the Apply button.
y
802.1X Authentication: Enable this function and the hyperlink of Radius Client List will appear. Click the
hyperlink to get into the Radius Client Configuration list for further configuration. Please refer to Radius
Roaming Out/802.1x Authentication in 5.3.1.1 Local User.
y
Trans Full Name: When enabled, the ID and postfix will be transferred to the RADIUS server for authentication.
When disabled, only the ID will be transferred to RADIUS server for authentication.
y
Server IP: Enter the IP address/domain name of the RADIUS server.
y
Authentication Port: Enter the authentication port of the RADIUS server and the default value is 1812.
y
Accounting Port: Enter the accounting port of the RADIUS server and the default value is 1813.
y
Secret Key: Enter the key for encryption and decryption.
y
Accounting Service: Select this to enable or disable the “Accounting Service” for accounting capabilities.
y
Authentication Protocol: There are two methods, CHAP and PAP for selection.
Notice: If Radius Server does not assign idle-timeout value, IAS-2000 v2 will use the local idle-timeout instead.