AirLive MU-7000AVs - Manual (Page 30)

6. Network Hard Disk (AirLive NDAS Mode)
5. Unbind window will appear. Make sure these NDAS Devices are ones that needs to be unbound and
click Yes
6. Two warning messages will appear.
- Once NDAS Devices are bound, all of the data will be last. Click Yes to continue.
- The new bound NDAS Devices must be mounted and formatted before it can be used. Click OK.
7. Now you can go back into the NDAS Device Management and Mount each of unbound NDAS Device.
8. Before using the NDAS Devices, please format each of the unbound device.
Unbind a Single NDAS Device
1. Go to NDAS Device Management and select a Bound NDAS Device you want to Unbind.
2. Unmount the NDAS Device by clicking on Unmount.
Note：If the bound NDAS Device is in use, a warning message will appear.
Make sure that no programs are using the NDAS Device and try again.
3. After you have unmounted the NDAS Devices, from NDAS Bind Management select one NDAS
device you want to unbind.
4. Right click on the NDAS Device and select Single.
5. All data will be lost if you want to convert it to a Single disk. Click Yes if you want to continue.
Note：Once the Binding has been broken, you cannot re-add any NDAS Devices to the broken
Bound device. You will have to recreate the Bind and format it again.
6. For formation of the NDAS Device, please refer to Chapter 9 Formatting NDAS Device.
7. When you are finished formatting, your NDAS Device should show up in My Computer as a local drive.
24
AirLive Mu-7000AV User’s Manual