AirLive WL-5460CAM - Manual (Page 94)

AirLive WL-5460CAM User’s Manual 93
the product by connecting a local computer to the unit, utilizing a
standard Crossover (hub to hub) Cable. If the problem is not
solved the camera might be faulty.
Q: Why does the Power LED not light up constantly?
A: The power supply used might be at fault. Confirm that you
are using the provided power supply DC 5V for the camera and
verify that the power supply is well connected.
Q: Why does the Link LED not light up properly?
A1: There might be a problem with the network cable. To
confirm that the cables are working, PING the address of a know
device on the network. If the cabling is OK and your network is
reachable, you should receive a reply similar to the following
(…bytes = 32 time = 2 ms).
A2: The network device utilized by the camera is not functioning
properly such as hubs or switches. Confirm the power for the
devices are well connected and functioning.
A3: The wireless connection might be at fault. In ad-hoc mode
make sure the camera wireless channel and SSID are set to match
the PC/Notebook wireless channel and SSID for direct
communication.
Under infrastructure mode make sure the SSID on the
PC/Notebook and the camera must match with the access point’s
SSID.
Q: Why does the camera work locally but not externally?
A1: Might be caused from the firewall protection. Need to check
the Internet firewall with your system administrator.