Aladdin Light Lift ALL300-CM - Manual (Page 9)

STEP 20
Fully thread screw collar loop or threaded stem that was supplied with chandelier to 1/4 IPS fixture coupler.
If chandelier was supplied with a 3/8 IPS screw collar loop, obtain 1/4 IPS x 3/8 IPS fixture coupler
included in parts bag. If chandelier was supplied with a 1/8 IPS or 1/2 IPS screw collar loop or threaded
stem, contact Aladdin Light Lift (877) 287-4601 to obtain proper coupler. See Diagram H.
Never install a chandelier on an ALL300 using metric threaded fittings. They will not thread together
properly and could cause the chandelier to fall, which could cause death, personal injury, and/or
property damage. Only use IPS threaded fittings.
Never hang a chandelier from an ALL300 using anything but the Aladdin Light Lift supplied fixture
coupler, bottom contact plate, and dowel pin. This could cause the chandelier to fall, which could cause
death, personal injury, and/or property damage.
STEP 21
Attach chandelier canopy to screw collar loop using screw collar rings on both top and bottom. An extra
screw collar ring (part C) is supplied in parts bag. See Diagram H.
Screw Collar Rings
1/4 IPS or 3/8 IPS
Fixture Coupler
Threaded Stem/Screw Collar
Loop Supplied with
Chandelier
STEP 22
Adjust chandelier chain to desired length and attach to screw collar loop.
Never cut, modify, or adjust the winch cable and never install an ALL300 with a cut, modified or
adjusted winch cable. Adjust the chandelier elevation by adjusting the chandelier chain or stem. An
ALL300 installed with a cut, modified, or improperly adjusted cable could cause the chandelier to fall,
which could cause death, personal injury, and/or property damage.
Diagram H
Canopy