ArcOne Clean Air Flow - Manual (Page 10)

Installation:
1. Line up the edges as shown (fi g. 2).
2. Slide the battery into the Blower.
3. Make sure there is an audible click as the battery is secured to the Blower.
4. Turn on the blower to check battery status (see section 2.3)
#2
2.2 Filters
Read the NIOSH approval labels found enclosed with the fi lter before installing
the fi lter into your Clean Air Flow
TM PAPR System.
THIS FILTER IS NOT MEANT TO BE REUSED. DO NOT CLEAN AND
REUSE. HE FILTERS SHOULD NEVER BE USED FOR PROTECTION
AGAINST GASES OR VAPORS. REFER TO SPECIFIC NIOSH FILTER
APPROVAL LABELS FOR SPECIFIC INFORMATION ON USAGE AND
LIMITATIONS.
Figure 2