ArcOne Clean Air Flow User Manual
Page 19
Cleaning Continued...
2.
Detach the breathing tube from the blower unit and the helmet assembly (see
section 4.3 & 4.4), and wipe the connection sites.
3.
Detach the face seal from the helmet assembly before cleaning (see section
4.5). Hand wash in a mild solution of clean water and mild detergent. Allow the
face seal to air dry before attaching it back into the helmet assembly.
4.
For helmet maintenance refer to the Auto-Darkening Welding Helmets-
“User Instruction Manual” that is enclosed.
5.
For all ArcOne Auto-Darkening lenses refer to the Auto-Darkening Welding
Helmets- “User Instruction Manual” that is enclosed.
6.
Let all components dry away from direct heat.
7.
Do a thorough inspection (section 3.3) of your Clean Air Flow
TM
PAPR sys-
tem.
Do not allow water to enter into the blower unit or the battery
pack. Failure to prevent water from entering into the blower
unit or battery pack could cause the product to fail, leading
to contaminant exposure resulting in serious bodily injury
or loss of life. Any fi lter, which has been directly exposed to
water, must be disposed of in accordance with state, local
and federal ordinances.
Do not clean any part of the system with gasoline, organic-
based solvents or chlorinated degreasing fl uids (such as
trichloroethylene). Failure to prevent cleaning with any of
these substances could lead to contaminant exposure and/or
product failure resulting in serious injury or loss of life.