Axcess AxcessView User Guide User Manual
Page 24
AxcessView User’s Guide
750.008.005 R0003
© 2007, Axcess International, Inc..
24
Figure 13 Setting up alarms and relays
2:
From the
Action
drop-down list, select the type of event that should cause an alarm
condition.
•
Normal Tag Read
– indicates a tag has passed through a RF field and
broadcasted it identification information to a receiver.
•
Panic Tag Read
– indicates an alarm code has been transmitted from a tag in
which the panic button on the tag has been depressed.
•
Tamper Tag Read
– indicates a tamper alarm has been transmitted from a tag in
which tampering or removal has taken place.
•
Asset Movement Alarm
– indicates an asset has been read without the
authorized owner within the specified time window.
•
Cabinet Open
– indicates a Door Open beacon has been transmitted from a tag
in which an external sensor detected the opening of the door.
3:
Select ASCII for the Relay Command Type.
4:
Verify that the ASCII command values are the following:
10c
for C1 and
11c
for C2
located at the top right.
5:
Select the TTL output, if any, that you want to trigger by selecting Trigger Relay C1
and/or Trigger Relay C2 check boxes located at the top right
.
6:
Select the check boxes by the information you want written to the log file in the Event
Log Fields.
•
TagID – tag ID number
•
FC – Facility Code