Barranca Diamond GP-6 Cabmaker - Manual (Page 10)

10
CONTENTS
In the shipping crate, you will find one Barranca Diamond GP-6 Cabmaker mounted to a 3/4" plywood
or plastic baseboard, one package of six rubber feet and mounting screws, one Ground Fault Circuit
Interrupter (GFCI) and one 1" x 1" x 6" sharpening stick.
The accessories for the GP-6 Cabmaker (belts) includes four diamond belts 6" x 1-1/2", Tool Cool bot-
tle, submersible pump and tubing, leather pad, three diamond paste syringes, three Polytex pads, 3M
On/Off cement, sharpening stick and 6" leather pad should be removed from the unit and put aside.
For the GP-6 (pads) the same accessories as the belts unit is accompanied by a Loc-Line magnetic
manifold pump, nozzle links/tips and nine 5" diameter diamond resin pads (50, 120, 220, 400, 800,
1,800, 3,500, 8,500, and 13,000 mesh), 5" rigid and backer pad and 5" rubber backer pad.
UNPACKING
Your GP-6 Cabmaker has been shipped from the factory thoroughly inspected and tested. Remove the
crating material (wood and plastic) from the baseboard and around the machine carefully using a Phil-
lips and standard screwdriver, wire cutter and box cutter knife. Any accessories should be removed
from the unit and put aside.
INSTALLATION OF RUBBER FEET
Enclosed with the unit you’ll find six rubber feet with fastening screws in a plastic bag to be installed
on the underside of the baseboard to level the polisher and reduced vibration during use. Six fastening
positions have been pre-drilled to allow for securely attaching the rubber feet with screws. Mount the
feet by tilting the base board up on one edge and install one of the supplied screws though a rubber
foot and into one of the six predrilled holes. Repeat with the other five sets of screws and rubber feet.
TRANSPORT
For safe transport, disconnect the submersible pump and power cord and remove lubricant and water
from the wheel reservoirs of the GP-6 Cabmaker.
GP-6 CABMAKER SETUP