Barranca Diamond GP-6 Cabmaker - Manual (Page 27)

27
manually (red button). Be sure to shut off the main motor by placing the switch lever to the OFF posi-
tion and disconnecting the power source. After allowing the motor to cool (2 to 3 hours), push the
red reset button on the side of the motor (Fig 46) and restart the unit by turning the switch to ON. If
the motor does not restart after a cool down period, remove the motor and have an authorized repair
service center for Baldor inspect the motor. Barranca Diamond can refer you to an authorized motor
repair service center in your area.
Please note: On GP-6 Cabmakers prior to serial number 0000750 (belts) and 001700 (pads), the
motors do not have a reset switch. Therefore it is imperative that if the motor should stop during op-
eration that the power to the main motor be shut off by placing the toggle switch in the MIDDLE/OFF
position as the motor will restart automatically once cooled down.
SUBMERSIBLE PUMP
Periodically remove the plastic inlet cover on the submersible water pump (Figs 47 & 48). Remove
the filter element (Fig 49) and clean any obstructions such as sludge or rock mud that may be found.
Clean the filter with warm, soapy water. Replace the filter (Figs 50 & 51) and test the pump to ensure
it is functioning properly.
Fig 47 - Water Pump Fig 48 - Slide pump inlet cover off the
pump body
Fig 49 - Slide the filter element out the
back of the inlet cover
Fig 50 - Replace clean filter Fig 51 - Filter installed
GP-6 CABMAKER MAINTENANCE