Bear Archery Compound Bow 2004 - Manual (Page 21)

21
Original OneCams are
equipped with a bowstring post
draw length adjustment sys-
tem. Typically, bows come from
the factory with the bowstring
attached to the center (#2) post.
To make draw length changes,
the bowstring is reattached to
one of the other posts. To make
such adjustments, a fixed or por-
table bow press should be used
to relieve tension in the bow’s
harness system.
To increase draw length,
attach the bowstring to a lower
numbered post. Going from post
#2 to post #1 increases draw
length by approximately 1/2 inch.
To decrease draw length,
attach the bowstring to a higher
numbered post. Going from
post #1 to post #3 decreased
draw length by approximately 1
inch. Such bowstring post draw
length adjustments will slightly
affect the bow’s draw weight.
A shorter adjusted draw length
will decrease draw weight. A
longer adjusted draw length will
increase draw weight.
Most discrepancies in buss
cable length can be adjusted
for either by adding or removing
twists from the buss cable or if
larger changes are required then
the buss cable attachment spool
can be repositioned in the cam to
one of its other locations.
ADJUSTING
DRAW
LENGTH
Original
OneCams