Bear Archery Compound Bow 2004 - Manual (Page 24)

ADJUSTING DRAW LENGTH
Rotating Module Cam
Note the string side of the cam has 2 axle holes num-
bered 1 and 2 (Fig. 1). You must relax the limbs of the
bow to change the axle locations. This can be achieved
either by relaxing the limb bolts or using a bow compres-
sor. The opposite side (fig. 2), the rotating module has
the letters A, B, C and D. There are also indicator marks
numbered 1 and 2. The indicator marks correspond to
the axle position on the opposite side of the cam. Use
the below information to set the draw and module posi-
tion for the desired draw length.
(Fig. 1 and 2 are on the following page)
Draw Length Axle Hole Module
20 2 2-D
21 2 2-C
22 2 2-B
23 2 2-A
24 1 1-D
25 1 1-C
26 1 1-B
27 1 1-A
24