Bear Archery Compound Bow 2004 - Manual (Page 32)

BOW SET-UP
Cableguard Installed and Adjustment
Post-mount below grip cableguard
Loosen locking screw(s) in side of base and slip
over post below the grip on the riser. Tighten the locking
screw(s) with the cableguard rod in the desired position,
keeping rod rotated toward the grip, rather than toward
the eccentric.
Above grip cableguard
Mound cableguard to the outside of the sight window
using the caphead screws provided. The cableguard
sideplate is compatible with dovetail or bolt-on sights.
To adjust cableguard rod for additional fletch clearance,
loosen the fasteners holding cableguard rod in place and
rotate. It is bast to position the cableguard rod as close
as possible to the center of the bow.
Fixed cableguard
Attach the cableguard to the riser below the grip
using the fasteners provided. This type of cableguard is
not adjustable for fletching clearance. To reduce deflec-
tion of the cableguard rod, loosen the fasteners and slide
the rod back, making sure to allow enough room for the
full travel of your draw length.
Inside/outside cableslide (Available on some 2 cam
models)
In addition to the cableguard adjustments described
above, additional fletch clearance can be obtained by
reversing the cable slide so that the cable rides to the
outside of the cableguard rod.
32