Troubleshooting – BKI VGG-CO Rotisserie/Convection Oven Combination User Manual
Page 27
Rotisserie/Convection Oven
Maintenance
25
Troubleshooting
VGG
Problem Cause
Possible
Solution
Unit will not turn on.
Main Power Isolator Light
is not lit.
Unit power plug disconnected
(where applicable).
Plug unit into mating receptacle.
Problem with building power
supply
Check circuit breaker at building power panel.
If problem persists, contact BKI service agent
for corrective action.
Unit will not turn on.
Main Power Isolator Light
is lit.
Blown Fuse
Contact BKI service agent for corrective
action.
Safety cut out thermostat tripped
or defective.
Contact BKI service agent for corrective
action.
Defective contactor.
Contact BKI service agent for corrective
action.
Rotor not rotating.
Door not completely closed.
Check that both doors are completely closed
Defective door switch.
Contact BKI service agent for corrective
action.
Blown Fuse
Contact BKI service agent for corrective
action.
Defective contactor.
Contact BKI service agent for corrective
action.
Defective motor or capacitor.
Contact BKI service agent for corrective
action.
Rotor will not rotate while
depressing Rotor switch
with door open but
operates with doors
closed.
Defective rotor switch.
Contact BKI service agent for corrective
action.
Oven does not heat at all.
Improper program settings.
Check program settings.
Improper parameter settings.
Contact BKI service agent for corrective
action.
Fan cover & circulation bottom
not installed or improperly
installed.
Check that components are properly installed.
Fan cover switch defective.
Contact BKI service agent for corrective
action.
Defective controller or contactor.
Contact BKI service agent for corrective
action.
Heating elements not
functioning.
Contact BKI service agent for corrective
action.
Oven heats up slowly
Improper line voltage.
Contact BKI service agent for corrective
action.