Carbolite 301 - Manual (Page 7)

Basic Operation
7 MC16-GB-C – 1.04
2.6 Checking the Temperature Setpoint from the Home display
Start at the Home display
Press an Up or Down arrow key.
The display will then flash
SP%C 3 times.
The Setpoint will show on the display for 3 seconds before returning to the Home display.
2.7 Changing the Temperature Setpoint
Start at the Home display
Press the Page key to scroll through the home menu until
SP%C shows on the display
Use the Up and Down arrow keys to alter the value (°C)
– a single press shows the current
setting, To alter, either keep pressed or press again.
The value will then be stored without any further input.
2.8 Changing the Temperature Setpoint Ramp Rate
Start at the Home display.
Press the Page key to scroll through the home menu until
SPrr shows on the display.
Use the Up and Down arrow keys to switch off or alter the value (°C/min) – a single press
shows the current setting. To alter, either keep pressed or press again.
The value will then be stored without any further input.
See section 4 for more information on Temperature Setpoint Ramp Rate.
2.9 Changing the Timer Time
Start at the Home display.
Press the Page key to scroll through the home menu until
T1, t2, t3, t4 or t5 shows on
the display.
Use the Up and Down arrow keys either to switch off or alter the value (Hr:Min)
– a single
press shows the current setting. To alter either keep pressed or press again.
The value will then be stored without any further input.
See section 5 for more information on The Timer.
T1
SPrr
SP%C